Originally Posted by new-Jedi

I left the needle in for 30 seconds,but after pulling out, I still had a little bit of test. Not a lot, but over 24 injections, it will be significant. I suspect there is nothing I can do to safe that test, so I put the cap back on the pin and put it in safety container. However, any tips on how to keep that from happening.

I'm positive I push the plunger all the way. Left it in for awhile. Not sure what more to do.

If a I had to guess at how much was left in, um maybe 3mg or something. Nothing I'd be willing to try to save, I don't want an infection.

Originally Posted by stillgoingstron

I don't really think you can do anything about it. I push a tiny bit of air through after the oil to expel as much oil as possible, but I'm sure there's always some residual oil that will never go through.

Originally Posted by new-Jedi

I left the needle in for 30 seconds,but after pulling out, I still had a little bit of test. Not a lot, but over 24 injections, it will be significant. I suspect there is nothing I can do to safe that test, so I put the cap back on the pin and put it in safety container. However, any tips on how to keep that from happening.

I'm positive I push the plunger all the way. Left it in for awhile. Not sure what more to do.

If a I had to guess at how much was left in, um maybe 3mg or something. Nothing I'd be willing to try to save, I don't want an infection.

Originally Posted by new-Jedi

It was still in plunger. I guess it makes sense it could have drawn back in. It did take some pressure to plung.

23x1 is size of pin.

Originally Posted by new-Jedi

Since there is some extra I'll try putting more plunger to get full 250mg.

Originally Posted by Big_Poppa_pump

wow, was that something you did not study?

Originally Posted by andyebs

where was the oil still in barrel or you mean little bit come back out the pin hole
what size is your pins