HOW TO DRAW FROM A VIAL

Wipe the top of the vial with an alcohol swab before
the needle enters. Let the alcohol evaporate
afterwards.

Pull back on the syringe approximately as much air as
you will be injecting. For example if you are
injecting 1cc, make sure to pull back 1cc of air into
the pin before you enter the vial.

Inject the air into the vial. This makes the drawing
much easier.

Pull back on the plunger until you get your desired
amount out of the vial and into the pin. Its better to
hold the vail upside down while you are doing this so
the syringe can be flicked to get the air bubbles out.


Now that you have the amount your are looking for into
the syringe, I would suggest to switch the needles.
It will dull the needle when it enters the top of the
vail so switching is a good idea. This isn't a must
but belive me makes things less painful. A sharp
needle is always a good needle.
-----------------------------------------------------------------------------------------------------------------------------------------------------------

BEFORE YOU INJECT


You do not want any infection going on so do not let the
needle touch anything. Make sure all the air bubbles
are out of the syringe. Keep flicking the syringe
until the air boubbles raise to the top so you can
push them out of the needle. Try your best to make
sure you have all of them out if you can. If some of
the juice comes out of the pin. Do not worry it will
be just fine.

Clean the site that you wish to inject in with alcohol
and your good to go.

__________________
Hypermuscles.Com do not promote the use of anabolic steroids without a doctor's prescription.
The information we share is for entertainment purposes only.
--------
Want to advertise on HyperMuscles and other popular sites? - Contact me